Alkaline Detergent Sanitiser for CIP Application in Milking & Beverage Plants
- Highly effective cleaning and sanitation
- Fully active in hard water
- Superior quality surfactants
- Easily to rinse
- Non corrosive -safe to use on metal surfaces
- Controlled foaming properties
Recommended Dilutions and Directions for Use
Always rinse the pipelines and equipment with clean water and allow to dry for few minutes before the application of BAYCIP.
Prepare the solution by mixing 100gm of BAYCIP in 40ltr of hot water. Allow the solution to circulate and run for 8-10 minutes at a temperature of 76-80˚C.
The equipment must be rinsed thoroughly with clean water after every application of BAYCIP and before it is used again. It must be ensured that no trace of a chemical agent be allowed to get into milk.
Carryout regular checks on the equipment i.e., pipes, tubes, teat cup, etc. and undertake the necessary descaling following the cleaning. Always check integrity of rubber components and seals.
Specifications (typical values)
An Alkaline mix including a blend of detergents,chlorine release agents (organic), corrosion inhibitors, sequestering and anti-caking agents.
Fine crystalline powder
pH (1% sol)
10 to 12
Shelf life 2 years if stored in original container, tightly sealed
Available in 10kg and 25kg UN approved packaging
The information contained herein is based on supplier’s own study and for information only. Customers are advised to ensure the suitability of the product for their intended application.